top of page

How Many Solar Panels Do I Need for My RV? Sizing Guide

3 days ago
5 min read

Disclosure: this post contains affiliate links. If you buy through them, ReneEnergy may earn a commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases.

White travel trailer with roof solar panels parked at a pine-forest lakeside campsite at sunset

How many solar panels do I need for my RV? For a typical boondocking setup that runs LED lights, a fan, a water pump, device charging and a 12 V compressor fridge, about 300 W of panels (three 100 W panels) covers a sunny summer day, and about 600 W covers short winter days. Your number depends on three things you can work out in ten minutes: your daily watt-hours, the sun hours where you camp, and how many days of battery reserve you want.

Quick answer: add up the watt-hours your RV uses in a day, divide by your local peak sun hours, then divide by 0.86 to allow for real-world losses. That gives the panel watts you need. Round up to whole panels, then size the battery to cover at least one cloudy day and the charge controller to match the array.

How many solar panels do I need for my RV? The three-step method

  1. Find your daily watt-hours (Wh). For each device, multiply its watts by the hours you use it per day, then add them up. A battery monitor that counts amp-hours over a real 24-hour trip gives the most honest number.

  2. Divide by peak sun hours. A peak sun hour is one hour of full-strength sunlight on the panel. Summer days in sunny regions give several; short winter days, shade and cloud give far fewer. NREL's free PVWatts calculator and solar resource maps show the numbers for your area and season.

  3. Allow for losses. Dust, heat, wiring and conversion all cut output. NREL's PVWatts model used a default of 14% total system losses, so dividing by 0.86 is a sensible planning allowance. Flat-mounted RV roof panels, which are rarely tilted toward the sun, can lose more.

Worked example: sizing a weekend boondocking rig

The loads below are illustrative assumptions, not measurements of any product. Swap in the wattage labels and hours from your own rig.

Load (assumed)

Watts

Hours per day

Wh per day

LED lights

30

5

150

Water pump

60

0.5

30

Roof vent fan

30

8

240

Phone and laptop charging

60

3

180

12 V compressor fridge (running about a third of the time)

45

8

360

Total

960

Now divide 960 Wh by sun hours and by 0.86 for losses:

Peak sun hours (assumed)

Panel watts needed

100 W panels

5 (sunny summer)

223 W

3

4 (average)

279 W

3

2 (short winter days or part shade)

558 W

6

The same arithmetic shows what one panel does: a 100 W panel in 4 peak sun hours, after 14% losses, gives about 344 Wh a day. So in this example, one or two panels would not keep up once the fridge is running.

Sizing the RV battery: LiFePO4 vs AGM

Panels refill the battery; the battery carries you through nights and cloudy days. In the example, 1.5 days of reserve means storing 1,440 Wh (960 × 1.5).

  • AGM: Lifeline, an AGM maker, advises limiting discharge to 50% depth of discharge to maximize cycle life, and says frequent deep discharges cut cycle life by more than half. Using 50%, the example needs about 240 Ah at 12 V.

  • LiFePO4: lithium iron phosphate batteries tolerate deeper cycling. Battle Born's data sheet for its 100 Ah 12 V battery lists 3,000 to 5,000 deep discharge cycles and a 100 A continuous discharge rating. Planning on 80% usable capacity (our assumption, which leaves headroom), the example needs about 150 Ah, so two 100 Ah batteries.

Matching the charge controller to the panels

The controller must handle the array's current and voltage. Victron's data sheet rates the SmartSolar MPPT 100/30 at 30 A and 440 W of panels on a 12 V battery, and the 100/50 at 50 A and 700 W on 12 V, both with a 100 V maximum panel open-circuit voltage. So the 300 W summer array fits a 100/30, while the 600 W winter array (about 50 A at 12 V) needs the 100/50. Our guide to MPPT vs PWM charge controller sizing explains the difference in more detail.

Roof panels vs portable panels

Roof panels charge all day without setup but sit flat and get shaded when you park under trees. A portable or suitcase panel can be aimed at the sun and placed in a clearing while the RV stays in the shade. You can also combine a fixed roof array with one portable panel for winter or shady sites. See portable solar panels for RVs for the basics.

How to choose RV solar parts

  • Panel watts and size: measure your free roof space first; it often limits the array more than budget does.

  • Controller: MPPT, rated for your array's watts at your battery voltage and for its open-circuit voltage in cold weather.

  • Battery: chemistry, usable Wh, continuous discharge rating, weight and low-temperature charge protection.

  • Cold weather: check charging temperature limits. Lifeline says not to charge its AGMs below –4 °F (–20 °C) without temperature-compensated charging, and Battle Born's data sheet lists a cold-charging protection feature.

Products that fit this example

These picks are based on published specs, not on hands-on testing.

  • Victron SmartSolar MPPT 100/50 (Bluetooth): 50 A, up to 700 W of panels on a 12 V battery, 100 V maximum PV voltage, 98% maximum efficiency per Victron's data sheet. Fits the 600 W winter array. View the Victron SmartSolar MPPT 100/50 on Amazon

  • Battle Born 100 Ah 12 V LiFePO4 (BB10012): 100 Ah, 31 lb, 3,000 to 5,000 deep discharge cycles, 100 A continuous discharge, internal BMS with cold-charging protection per its data sheet. Two cover the example's reserve. View the Battle Born BB10012 on Amazon

FAQ

Is 200 watts of solar enough for an RV?

For lights, a fan and device charging, often yes. Add a compressor fridge and the example above needs about 280 W at 4 sun hours, so 200 W falls short on average days. Run the three-step method with your own loads to be sure.

Can solar panels run an RV air conditioner?

Only with a large battery bank, an inverter sized for the air conditioner's starting surge and far more panel watts than most roofs hold. An older post looks at one setup in can a power station and two panels run an RV air conditioner.

Do RV solar panels work in winter?

Yes, but short days and a low sun cut daily output sharply. The example assumes winter sun hours are half the average, which is why its winter array is twice the size; check PVWatts for your own location and month. Batteries also need protection from charging when very cold.

Safety note

This post is general information, not electrical advice. Use a qualified RV technician or licensed electrician for wiring, fusing and shore-power connections.

Thinking about going solar at home too?

The same sizing logic applies to a house, just with bigger numbers. Get your personalized solar quote.

Related reading

Sources

  1. NREL, Dobos, Freeman and Blair, "Improvements to PVWatts for Fixed and One-Axis Tracking Systems" (2019), default 14% system loss: nrel.gov/docs/fy19osti/74097.pdf

  2. NREL, Solar Resource Maps and Data: nrel.gov/gis/solar-resource-maps

  3. U.S. EIA, Where solar is found: eia.gov

  4. Victron Energy, SmartSolar MPPT 100/30 and 100/50 data sheet: victronenergy.com

  5. Battle Born Batteries, BB10012 data sheet: battlebornbatteries.com

  6. Lifeline Batteries, FAQs (AGM depth of discharge and charging): lifelinebatteries.com/faqs

Fact-checked November 14, 2026.

Comments


Technical films · About · H2Hub · Hydrogen industry directory · Blog · Shop · Feasibility template · Privacy policy · Affiliate disclosure · Contact

As an Amazon Associate, ReneEnergy earns from qualifying purchases.

bottom of page